Engenius 2610 client bridge needs to be reset periodically to work

I have 3 Engenius 2610 Access Points. One is set as an Access Point, the 2nd and 3rd are set as a client bridge. The two client bridges have a strong signal -40 and -30 respectively. They have the correct WPA2 settings, SSIDs, etc. They connect to the AP and work fine most of the time. However, about once a week the client bridges fail to interact with the Access Point. They cannot be pinged or communicated with in anyway. Once I reset the AP (not the bridges) they reestablish communication and begin working again.

During the "down time" the Access point conintues to "work" without going down. It remains on, accessable by other devices (laptops) and is opperational. It will also show the two CB's in its connections table sometimes.

What would be causing this issue, and how can I maintain a constant connection? I have IP polycom phones connected to the client bridges and from time to time a laptop or two, but nothing that should crash the connection.

Solution: Engenius 2610 client bridge needs to be reset periodically to work

You may have to wait for a future firmware. Also get in touch with their support, they may know of the issue already.

Popular Tags

Browse All Tags