Browse by Tags

  • USB to FDD Interface, Interface USB with 3.5" 720K FDD

    I want to Interface USB to Floppy Disk Connector (3.5" 720KB only not 1.44), Acctually I have a machine which is save data in floppy disk only (3.5" 720KB only not 1.44) Now I want to save/load data into/from USB Pen drive, so I want to Interface USB devices using port with FDD Connector which...
    Posted to Other (Forum) by hardware on 10-29-2009
  • lost carrier on ethernet interface

    What is the cause of lost carrier stats to rise on ethernet interface? Here are the stats: Ethernet0/0 is up, line protocol is up Hardware is AmdP2, address is 00d0.58a9.a940 (bia 00d0.58a9.a940) Internet address is 192.168.106.20/24 MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, reliability 255/255,...
    Posted to Routers (Forum) by hardware on 07-26-2009
  • How to clear an interface configuration?

    How does one clear the configuration for a Serial interface on a Cisco router running 12.4T?
    Posted to Routers (Forum) by hardware on 07-08-2009
  • What is a loopback interface?

    What is a loopback interface? In what situation will you use one? How do u configure one on a cisco router?
    Posted to Routers (Forum) by hardware on 07-03-2009
  • Cisco  Bridge Virtual Interface (BVI) help

    I am missing something in my configruation I think. I have the T1 up on the controller and the BVI1 group in place I just can not get the two to talk across the T1. Help.. Here is my current config for both routers - everything is the same except the BVI1 IP address - XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXx...
    Posted to Routers (Forum) by hardware on 07-03-2009
  • configuring serial interface on cisco 1841 router for frame-relay

    Hello expert, I have a cisco 1841 router (dsc/csu not embedded), I am about to configure for frame-relay platform. I read a few article as preparation but, I am confuse on the issue of the serial interface configuration. There seem to a serial interface and a sub interface been mention thru out the arictle...
    Posted to Routers (Forum) by hardware on 07-02-2009
  • Config Cisco router to recieve DHCP on WAN interface.

    I'm setting up a cisco 871 Router. I need to set the wan port to recieve a DHCP address from the ISP I believe I have it set up the right way. I am not able to ping past the inside interface. 192.168.1.1 What is the command to display what IP address I have recieved? How can I tell if I've recieved...
    Posted to Routers (Forum) by hardware on 07-02-2009
  • DSL PPPOE Connection Fails with Interface Virtual-Access1, changed state to down

    First my apologies for the large post but this is the information that was requested in the previous posts that I have read. Following are the 2 posts that I seen and I have followed each of there suggestions and still I have this issue. I wish that I were allowed to award more points for this question...
    Posted to Routers (Forum) by hardware on 07-02-2009
  • SNMP OID's for Cisco 19/29/3500's

    In a telnet session to a Cisco Catalyst 2924XL switch I can issue the following command: show mac-address-table interface fastethernet 0/3 to find out the mac address and VLAN of the network card on the computer attached to this switch on port 3. I'm looking for the appropriate OID's so that...
    Posted to Routers (Forum) by hardware on 06-27-2009
  • OSPF and passive interface

    Of all the book I have read on OSPF none really address the issue of passive interface been used with OSPF. My concern is if on my network I have OSPF configured and I have a T1 connection to a network that maybe running OSPF also (different from mind), would that network see hello packets from my OSPF...
    Posted to Routers (Forum) by hardware on 06-25-2009
Page 1 of 9 (83 items) 1 2 3 4 5 Next > ... Last ยป